Second Skin Audio Luxury Liner Pro Sheet | Free Shipping | 18sqft | 2 Sheets

Description

New Second Skin Audio Luxury Liner Pro Sheets 18 Sqft
2 Sheets
Road noise, especially on the highway, can be enough to distort any car audio system, and in some vehicles can even prevent a normal conversation. Luxury Liner Pro is our best automotive noise insulation barrier, designed to be used on top of our vibration dampers to block the transfer of the most difficult airborne sound waves. Turn any vehicles into your personal of calm by adding a noise barrier to your sound deadening.
3/8” thick sheet of fused mass loaded vinyl and closed cell foam
Each sheet is 24” x 54” (9 Sq Ft)
Weight: 1.25 pounds per square foot
Raw virgin mass loaded vinyl (MLV) is flexible and won’t smell, perfect for vehicles
Closed cell foam (CCF) acts as a decoupler to simplify installation
Insulates for both extreme noise and temperature
Apply with a spray adhesive or strong double-sided tape
Made in the USA
Recommended Install Locations
Floor - front firewall all the way back to the rear deck seat wall
Firewall - cabin side
Trunk - entire floor including over the wheel wells
Doors - outer or inner door skin
Application Instructions
For best results, Luxury Liner Pro should be applied on top of a sound deadener, such as our Damplifier Pro. It’ll be the final layer of your multi-layer sound insulation bubble.
If upholstery or carpet is not already out, remove it. Ensure there’s no loose debris, rust, dirt, or waxy oils.
Cut Luxury Liner Pro to the desired size with a sharp utility knife or a good pair of scissors. Be sure to cut to a size that will allow you to reinstall the carpet and upholstery trim. Do not cover wires, drain holes, or mechanical devices. This part of the project is more art than science, as you need to have as few gaps as possible in your noise barrier while avoiding interference with other parts of the car.
Spray a high tack spray adhesive (ours is very strong) on both application surfaces. Apply one coat on the foam side of the Luxury Liner Pro, and one on the application panel or the foil side of your Damplifier Pro. Be mindful of adhesive overspray and ventilation.
Wait 1-2 minutes for the gases to be released from the glue and it to become tacky. Then press the tacky side of the Luxury Liner Pro down to the panel. Apply constant pressure over the entire surface for several minutes to ensure a solid bond.
Seal any exposed edges or seams with foil insulation tape.The goal is to create as close to an unbroken noise barrier as possible.
Factory carpet can be replaced immediately. Aftermarket carpet kits can be attached directly to the exposed mass loaded vinyl side of Luxury Liner Pro.